It is one of the best and most time consuming decisions I ever made for my modding – buy a 3D printer. After brutal failures and fun learnings I could start to design and put out prototypes. I knew from start of this mod I wanted to do something special with the GPU. After all,
After a new modding room and a full stack of amazing tools thx to Ryobi I could get back to modding and project Angl3d Ti. Some parts left to do on the complicated front as well as closing up the bottom and front. It was suddenly a dream. The last 3 angles to finish the
After finishing my modding room and after some back and forth I pulled the trigger on a 3D printer on Black Friday. 2 days later it arrived with, what would become a 2 week headake. I took a decision to buy the Creality CR-10S. Just couldn’t justify paying almost 250% more for a Prusa 3.
Last piece before the exterior frame is complete is the front. It is also the hardest due to my design choice to expose the 3 front fans. As I have a challenge with the precision with my hand tools, I decided that the only way to get a prefect fit, is to make the holes
Final stretch of the top exterior acrylic case part. Wanted to bring back more angles and tigh the entire design together with the previously created PSU Shroud. First task was to file down the front edge to make sure it was a perfect fit against the front. I made the front and top 3mm
Work progressing with building the main structure and most part of the top case part. This is an important part of the mod as it will either make it or brake it. I need to tie it together with the front and base part. I hope I will end up with a feeling of one cohesive
It was time to start working on the 3rd and final external case part, the top. With the front IO panel as the major component to work around and into this case part as the biggest challenge. I also need to figure out a good way to bridge the top part with the front part
I mentioned in an early stage of this mod that I realized that I ran into a problem. That problem is the front IO panel. Reason is of course that it needs to be fixed before I can fasten the front and top cover. That also means that I need to figure out how to
With the base structure done from the previous part it was not much to wait for. The hard part about this part of the mod of creating an angled front structure is that each piece will influence all the others. The size, the angle, the shape all influence eachother. Almost like laying a puzzle without
Was with extra excitment that I was ready to start working with the front case part of this mod. I have had an idea about the front since I started this project. In fact, it was the idea of the front that even started this whole project. First I need to ensure it’s located