Last piece before the exterior frame is complete is the front. It is also the hardest due to my design choice to expose the 3 front fans. As I have a challenge with the precision with my hand tools, I decided that the only way to get a prefect fit, is to make the holes
Final stretch of the top exterior acrylic case part. Wanted to bring back more angles and tigh the entire design together with the previously created PSU Shroud. First task was to file down the front edge to make sure it was a perfect fit against the front. I made the front and top 3mm
Work progressing with building the main structure and most part of the top case part. This is an important part of the mod as it will either make it or brake it. I need to tie it together with the front and base part. I hope I will end up with a feeling of one cohesive
I mentioned in an early stage of this mod that I realized that I ran into a problem. That problem is the front IO panel. Reason is of course that it needs to be fixed before I can fasten the front and top cover. That also means that I need to figure out how to
With the base structure done from the previous part it was not much to wait for. The hard part about this part of the mod of creating an angled front structure is that each piece will influence all the others. The size, the angle, the shape all influence eachother. Almost like laying a puzzle without
Was with extra excitment that I was ready to start working with the front case part of this mod. I have had an idea about the front since I started this project. In fact, it was the idea of the front that even started this whole project. First I need to ensure it’s located
Big progress on the base structure and bottom part of the custom pc casemod. With the last part of this mod finished with a fairly solid structure, this part will be all about filling the gaps in the exterior acrylic and make one solid structure. With the front part of the bottom almost done, I
A custom hand made exterior case in acrylic for the Dark Base Pro 900 will be a challenge. A huge one, but a challenge I knew from start would be needed to complete the vision of the project. TBH, I don’t even have a plan, but need to make it up as I go along.
With a full EK water block cooled ASUS 1080Ti it feels almost mandatory to do a vertical GPU. One thing I learned with Project Zeuligan is that the back of the be quiet! Dark Base Pro 900 is a little to flexible to support a GPU without some sag. Therefor I decided to do a
After over 100 hours of hand filing and acrylic focus the base shape of the PSU Shroud for project Angl3d Ti is finished. Managed to create it divided into two pieces without a visible edge. One of the last pieces of the PSU Shroud mod. All 3 sides angled in opposite directions and created with